electrifly reflection, Инструкция по эксплуатации

Страница: 10 / 24

❏
9. Install a Z-bend clevis (A1) into a clip hinge control
horn (C1). Using the 3 x 145mm [1/8" x 5-11/16"] rudder
post tube as a guide, glue three clip hinges and the clip
hinge control horn to the rudder.
❏
10. Snap the tailwheel (D4) into the tailwheel bracket
(D5) and slide the tailwheel bracket onto the 3 x 20mm [1/8"
x 3/4"] tailwheel tube. Glue this assembly into the slot in
the rudder.
❏
11. Slide two hinge retainer rings (C3) onto the top of the
rudder post. Align the rings with the slot in the TE of the
fuselage. Secure each ring with a drop of glue on the outside.
Glue the rudder post tube to the TE of the vertical fuselage.
❏
12. Snap the rudder onto the rudder post.
❏
1. Cut the wings and all four ailerons free from the foam
sheet. Identify the top and bottom wings. The bottom wing
has the aileron servo bay.
❏
2. Following the Expert Tip previously described, use a
3 x 700mm [1/8" x 27-9/16"] wing trailing edge tube as a
guide to glue hinges into the slots in two of the ailerons.
These will be the top ailerons.
❏
3. Insert offset Z-bend clevises (A2) into opposing sides
of two clip-hinge stand alone control horns (B1).
❏
4. Using the Expert Tip previously described, use a 3 x
700mm [1/8" x 27.5"] wing trailing edge tube as a guide to
glue hinges and one control horn each into two of the
Assemble the Wing
10