ELECRAFT KXPA100, Руководство пользователя

Страница: 6 / 13

6
Operation
Power On
1. Ensure a suitable 50 ohm load is attached to the ANT 1 connector on the rear panel (Figure 1,
{14}). A dummy load is strongly recommended for initial tests.
2. Enable the power supply by sliding the front panel switch (Figure 2, {11}) to the On ( I ) position.
The
POWER
LED should light.
IMPORTANT
Switches with a legend above and below the pushbutton have two functions. Tap
(press briefly) to activate the function labeled above a switch. Hold to activate the
function labeled below the switch. In the text, tap functions are shown like this:
T E M P
. An example of a hold function is
P K H O L D
.
Figure 2. KXPA100 Front Panel.
NOTE: If at any time the
FAULT
LED {7} lights, refer to Fault Conditions, pg. 8.