ELECRAFT KXPA100, Руководство пользователя

Страница: 4 / 13

4
Installation
The KXPA100 is designed for installation in either a home station or mobile environment.
Two important mounting criteria must be observed. The heat sink fins must be oriented vertically to optimize
natural convection air currents and the power cable run must be as direct as possible.
There are three recommended mounting positions: base down flat, with the heat sink horizontal and fins
pointing up; front panel down, with the fins vertical; and rear panel down with the heat sink fins vertical. Do not
place other equipment, papers, etc., on top of the KXPA100. Keep the KXPA100 out of direct sunlight if
possible.
The KXPA100 draws as much as 24 A of power supply current. The power cable should be as short and direct
as possible to minimize voltage drop. The red power lead connects to positive (+) 13.8V and the black lead
connects to the negative terminal. The negative terminal is common to chassis ground. If the supplied cable is
not long enough, make a cable using no smaller than #10 AWG conductors. For mobile installations, connect the
power cable directly to the battery terminals.
The following text uses braces to refer to numbered elements in the front- and rear-panel illustrations below. For
example, {14} refers to 14, the
RF OUTPUT connector.
Figure 1. KXPA100 Rear Panel