Hardware
The hardware for assembling the Multi-Purpose Wire
Cart is enclosed in the MH8220-I Hardware Kit (bag).
The kit contains the items shown below.
Assembly Instructions
1
With Support Frame (A) on flat surface, push
down firmly on Frame Connector (C) until Ball
Pin in Support Frame (A) snaps into hole in Frame
Connector (C)as shown in Figure 1. Repeat for the
second Frame Connector.
FIGURE 1
FIGURE 2
2
Line up Support Frame (B) over the Frame
Connectors (C). Push down until Ball Pins in
Support Frame (B) snap into the holes in the Frame
Connectors (C) as shown in Figure 2.
3
With Wire Guide facing down, position the Top
Frame Connector (D) in between the Support
Frames (A and B). Secure using the 1/4-20 x 1-1/2”
Carriage Bolt (1), 1/4 “x 1/2” Flat Washer (2), and ¼-
20 Nylon-Insert Locknut (3) as shown in Figure 3.
4
With the unit in a horizontal position, insert the
Bottom Frame Connector (E) into the holes in
the Support Frames (A and B). Push down equally on
both sides until Ball Pins in the Bottom Frame
Connector (E) snap into the holes in the Support
Frames (A and B) as shown in Figure 4.
5
Stand the unit in a vertical position. Insert the
Zinc Plated Wheel Axle (G) through the bottom
hole of Support Frame (A). Using Wheels (H), 3/4” x
1-1/2” Flat Washers (4), 1-1/2” Cotter Pins (5) secure
Wheels and Axle as shown in Figure 5.
NOTE:
After inserting 1-1/2” Cotter Pins (5) through
holes in
Wheel Axle
(G), bend
both sides of
Cotter Pin
upward to
lock in place.
6
Insert the Zinc Plated Reel Shafts (F) through
the holes in the front of Support Frames (A
and B),
secure using
3 x 65 Hitch
Pin Clips (6)
as shown in
Figure 6.
FIGURE 4
FIGURE 5
FIGURE 6
Hardware
Kit
MH8220-I
FIGURE 3
