Elebia C5, Руководство пользователя

Страница: 9 / 20

9
Disclaimer: This user manual is for information only. The manufacturer reserves the right to modify any specifications.
FCC, IC, CE & ARIB
EN
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmit-
ter, except in accordance with FCC multi-transmitter product procedures.
Any changes or modifications not expressly approved by the warranty of this device could void the user’s
authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna; Increase the separation between the equipment and receiver.
Power Supply
Available Code Combinations
Detection of Errors in Transmission
Buttons
Frequency Selection
Frequencies
Communication
Radiated Power
Antenna
Range
Working Temperature
Dimensions One 3V lithium battery (CR2032)
65,536 different combinations
2 CRC bytes + Forward Error Correction
2
1
865.95 MHz / 869.85 MHz
Bi-directional return of receiver battery status
under 5 dBm
Printed circuit
100 metres
/ 330 Feet
-20 ºC to 85 ºC
/ -4 ºF to 185 ºF
Minitel box (68 x 52 x 17 mm
/ 2.68 x 2.05 x 0.67 in.)
The eINST remote control has to be placed in the crane relay cabinet, where only simple wiring is needed. It
may be used by pairing to a free channel of the crane’s master control. It is compatible with all cranes.
Available as 24 V DC or 48 V DC
Dimensions: 80 x 140 x 45 mm. /
3.15 x 5.51 x 1.77 in.