11
Mode
Method of operation
Operating time
Whitening
Removes plaque, whitens front teeth and
eliminates discolouration
Two minutes, impulse every
30 seconds
Cleaning
Daily plaque removal
Gentle
Cleans sensitive teeth and gums
Gum care
Massages gums
Deep cleaning
Removing particularly stubborn plaque
and discolouration.
Three minutes, impulse every
45 seconds
• The toothbrush will always begin working in the
last mode selected.
USE
• Place the head (7) on the spindle (1) – Fig. A
• Switch on the device, select the operating mode
(see above) and switch it off.
• Wet the bristles of the head (7).
• Apply a small amount of toothpaste to the wet
bristles.
• Place the toothbrush in your mouth, set it at the
right angle (Fig.C) and turn it on.
• Brush your teeth in circular motions as described
below without applying too much pressure to
the teeth and gums.
• The brushing cycle takes 2 minutes. The
toothbrush will generate an impulse every 30
seconds.
• The device will switch off automatically at the
end of the set time period.
• The device operation can be stopped at any
moment by pressing the switch (3).
• Rinse the mouth after brushing. Specialist rinses
may be used.
• Remove the head (7), wash it thoroughly and set
aside to dry.
• Wipe the device and set it down in a dry place or
on the charging station (8).
TEETH CLEANING – RECOMMENDATIONS
• Divide the teeth into 4 areas – Fig. B.
• Brush each part for approximately 30 seconds
(approximately 45 seconds in deep cleaning
mode). The toothbrush signals when the time
is up.
• Apply the head bristles to the teeth correctly –
Fig. C
CLEANING AND MAINTENANCE
Clean the appliance after each use.
• Before cleaning, make sure the device is turned
off.
• Do not immerse the charging station (8) in water.
• Do not use strong agents, cleaning agents or
cleaning products which may damage the
surface.
• Wipe the charging station (8) and housing (2)
with a damp cloth.
• Rinse the head (7) thoroughly. Do not compress
or pull the bristles to avoid damage.
ENVIRONMENTAL PROTECTION
• the appliance is made of materials which can be
recovered or recycled
• the appliance should be handed over to the
appropriate centre of collection and recycling of
electrical and electronic equipment
Содержание SONIC SD200
Страница 3: ...3 1 3 6 7 8 5 2 A B C 4...
Страница 21: ...21 8 8 c Eldom sp z o o 2...
Страница 23: ...23 2 30 3 45 3 4 3 3 3 3 7 1 A 7 C 2 30 3 7 8 4 B 30 45 C 8...
Страница 24: ...24 1 2 1 2 1 2 1 2 8 2 7 PROBLEMS SOLUTIONS...