10
1
2
3
4
5
6
7
8
9
R
Clothes shaver manual GDS4
TECHNICAL DATA
GENERAL DESCRIPTION
1. Protective cover
2. Shield
3. Blade
4. Height adjuster
5. Body
6. Container
7. ON/OFF switch
8. Lamp
9. Supply socket
10. Little brush
- power: 3W
- voltage supply: 230V ~ 50Hz
- battery: Ni-Cd 600 mAh
- loading time: 10 hours
HANDLING
- before start-up fix a shield (2).
Do not switch on the shaver when the shield is loose.
Note. The appliance does not operate in case the shield is fixed in an improper manner.
- The shaver starts the operation after the switch has been slid into the „1" position.
- move the shaver along clothes laying on a flat surface
- In order to switch a unit off slide the switch (7) into „0" positio
LOADING
The appliance is equipped with an internal battery which requires
approx. 8 hours to be loaded up. In order to extend the shelf-life
of a battery a loading should be carried out as a single, non-stopped
cycle after a battery has been totally unloaded. Loading of the
battery is signalized by a control light/lamp (8).
NOTE
The control lamp does not go off when the battery has been
loaded up.a.
In order to load the battery up;
- set the switch (7) into „0" position
- connect the power supply cable to the socket (9)
- plug the unit in
After loading up the appliance must be de-plugged and the
power supply cord must be removed from a socket (9).
1. Do not shave clothes in case clothes are at a body. It may cause wounds on a body.
2. When shaving clothes pay special attention to:
- areas around buttons and zips
- protruding parts
- connections – sews
- object glued to clothes
- delicate parts
3. Before use try the unit on a hidden part of a cloth.
4. Move the unit acc. to a pattern on a cloth.
5. If required move the unit alongside – vertically and horizontally
6. In case of ‘flat ‘materials lay two layers of a cloth and shave them on an iron board.
7. Do not switch the unit on when it is unnecessary, it may result in reduced life of the shield and the blade.
GUIDELINES
- the unit is made of materials which may be reused or re-cycled
- it must be provided to a relevant point specializing in collecting and recycling of electric and electronic
appliances
ENVIRONMENT PROTECTION
INSTRUCTIONS FOR USE
4
