Eldom 5908277382735, Инструкция по эксплуатации

Страница: 10 / 42

10
CLEANING AND MAINTENANCE
After using the appliance, the chamber of cutting knives should always be cleaned. For this
purpose, open the cutting head (1) by pressing the clipper blades with your thumb in the
direction shown in phot. 2. Protect the blades against falling down.
Clean the blades with the brush included in the set.
Cutting blades must be maintained on a regular basis. Put one to two drops of oil between
the blades and turn the appliance on for a few seconds.
Do not use hair oils, fat, oils mixed with refined kerosene or other solvents.
Do not immerse the appliance in water. Before cleaning, unplug the appliance and turn it off.
Do not use any cleansing agents which are strong or may damage the surface.
Wipe the casing with a moist or dry cloth.
HAIR CLIPPING
- Make sure the appliance is clean, correctly assembled and oiled.
- Before clipping the hair, comb it to make it more natural.
- to install the attachment (5), slide it into the locks (10), photo 1.
You can use the attachment to trim hair to the length range of 3-15 mm.
Take off the attachment to shorten the trimming length.
Use the revolving ring (2) to set up the hair trimming length..
The rotating ring (2) allows for control of hair length.
- It is recommended to start clipping with the use of the comb head for longer hair.
- Clip small areas by moving the appliance slowly through the hair.
- Start clipping from the neck upwards or from the forehead and the temple upwards.
- Hold the appliance gently under the hair, so that the comb heads are pointed upwards and
lie flat on the head.
- in case of thick hair you can move the slider (9) left - this will move out a plastic cap that
blocks the slipping-in of some hair under the head (1) and thus facilitate trimming. When the
hair is pre-trimmed, move the slider (9) right and continue trimming.
Use the switch (3), position „ON” to switch on the clipper. Additionally, the indicator lamp (4)
will go on to indicate that the clipper is operating.
Do not use the appliance for clipping wet hair.
The cutting blades are wear parts and should
be maintained on a regular basis.
The are not covered by the guarantee.
phot. 1 phot. 2