LAN MESSENGER
Ethernet Auto Dialler
LAN MESSENGER
Ethernet Auto Dialler
5.4. Authentication
In this section the user can set up the details required for logging in to ELAN Configuration Web Server.
8
User name
– User name required for authorization to log in to LAN MESSENGER web server. Default user name is 1234.
Password for user
– Password for authorization to log in to LAN MESSENGER web server. Default password is 1234.
Retype password
– Repeat the password for confirmation when changing it.
5.5. Statistics
This section provides the information regarding the established TCP connections.
9
Socket
– Sequence number of the socket.
State
– Socket state:
•
CONNECT
– Successfully connected to remote IP address.
•
LISTEN
– Ready for connection.
•
CLOSED
– Connection is closed.
Rem IP
– Remote IP address the device is connected to.
Rem Port
– Remote port number the device is connected through.
Loc Port
– Local port number of the device.
Timer
– Connection uptime in seconds.
5.6. Inputs
The following section is intended for input configuration.
10
Mode
•
Digital
– The device measures the input voltage resulting in input state (violated/restored) change in accordance with the Thresh-
old parameter and data message delivery to the destination IP address (-es).
•
Off
– Input disabled.
Type
•
NO
– Sets input type as normally-open. Connecting the circuit leads to input violation. Default parameter.
•
NC
– Sets input type as normally-closed. Disconnecting the circuit leads to input violation.
Threshold
– Sets the voltage value (mV) for Digital input mode. The device considers the input violated/restored once this value is exceed-
ed. Value range is
0... 10000
mV. Default value is
1800
mV. It is NOT recommended to change the default value.
For more details on input wiring, please refer to general wiring diagram provided in
2.3. Wiring Diagrams.
5.7. Outputs
This section is intended for output C1 and C2 control.
The LAN MESSENGER device comes equipped with 2 open collector outputs C1 and C2 designed for electrical appliance connection. Nor-
mally, outputs can be used to open/close garage doors, activate lights, heating, watering and much more. When output turns ON, the LAN
MESSENGER triggers any equipment or relay connected to it (see
2.3. Wiring Diagrams
).
When input Z4 is in use, output C2 will not be available. In such case C2/Z4 terminal can not be used as open-collector output. In order to use
C2/Z4 terminal as open-collector output, disable input Z4. For more details on input configuration, please refer to
5.6. Inputs
.
NOTE:
Output C2 and input Z4 DO NOT operate simultaneously.
11
The output can be turned ON or OFF by selecting a corresponding output status ON or OFF from the drop down list and clicking the
Save
button afterwards. By default, output C1 and C2 are turned OFF.
Intelligent Security & Fire Ltd.
