elddis AUTOQUEST 115 2012, Руководство пользователя

Страница: 17 / 94

6-4
GETTING STARTED
ROAD SAFE GAS REGULATOR
Operating instructions
The use of upright gas cylinders from which gas is
taken in the gas phase is mandatory for the
operation of gas regulators, gas equipment and
gas systems. Gas cylinders from which gas is
taken in the liquid phase (e.g. for fork lifts) must
not be used, since they would result in damage to
the gas system.
Taking into operation
Open gas remote switch if present.
1. Open the cylinder’s valve.
2. Firmly press the green reset button on the
high pressure hose.
3. Press gas flow monitor reset button (green
button) on gas pressure regulator
slowly .
4. Release gas flow monitor reset button
(green button) on gas pressure regulator
slowly (3 seconds). If no pressure point is
felt when the button is pressed again, the
regulator is ready for operation (repeat
procedure if necessary). Start the gas-
burning devices if desired. If the gas
cylinders are closed, SecuMotion may switch
off after an extended period of no usage.
Changing a gas cylinder
Please use the included screwing tool to attach
and remove the high pressure hoses. It will help
you generate the necessary tightening torque and
will prevent damage to the screw fittings, which
may otherwise result from using an improper
tool.
When the cylinder is connected please ensure
that the high pressure hose is not placed under
any strain.
Residual gas: No smoking! No open flames!
- Close the empty gas cylinder’s valve.
- Remove the high pressure hose from the gas
cylinder and remove the clip-on adapter, if
present.
- Attach the high pressure hose to the full gas
cylinder and apply the clip-on adapter, if
present.
- Open the full cylinder’s valve.
- Press the hose-break safety device and the gas-
flow monitor (see “Taking into operation”).
Anytime after making changes, check the hose
connection to the cylinder valve for leaks (see
“Checking for leaks in the high pressure area”).
Exchanging hoses.
Please use the included screwing tool to attach
and remove the high pressure hoses. It will help
you generate the necessary tightening torque and
will prevent damage to the screw fittings, which
may otherwise result from using an improper
tool.
Residual gas: No smoking! No open flames!
- Close the gas cylinder’s valve.
- Remove the high pressure hose from the gas
cylinder (or from the slip-on adapter) and from
the regulator inlet.
When performing a hose change, please ensure
that the white gasket provided with the hose
(hose outlet - regulator inlet) is correctly
installed and not damaged.
We recommend that the gasket (part no. 50020-
76300) be replaced with every hose change.
- Screw country-specific high pressure hose to
SecuMotion inlet and cylinder (or to adapter).
Open the gas cylinder’s valve.
- Press the hose-break safety device and, if
necessary, the gas-flow monitor (see “Taking
into operation”).
Anytime after making changes, check the hose
connections to the cylinder valve and to the inlet
of the SecuMotion gas-pressure regulator for
leaks.
High Pressure Gas Hoses
You should only connect to this regulator using a
length of approved high-pressure hose not
exceeding 450mm from the gas cylinder to the
regulator. These approved high-pressure hoses
are available from your Elddis Retailer. These
hoses are connected using screw thread fittings,
which will make a seal if connected and tightened
using a spanner. Once the hose is securely
connected turn on the gas tap above the
regulator, then turn on the gas bottle to allow gas
to flow into the motorhome.
In order to make all your motorhome gas
appliances operational it is necessary to open
each appliance gas tap as detailed in previous
column. All your gas appliances should now be
operational. Instructions on how to use each
appliance are detailed later in your handbook.