Disposal
Conformity
If, despite correct handling, faults or mal-
functions occur or if the product was damaged,
please contact your retailer or the manufactu-
rer.
ELDAT GmbH
Im Gewerbepark 14
15711 Königs Wusterhausen
Germany
Phone:
+ 49 (0) 33 75 / 90 37-310
Fax:
+ 49 (0) 33 75 / 90 37-90
Internet: www.eldat.de
E-Mail:
Waste electrical products and batteries not
be disposed of with household waste!
Dispose of the waste product via a
collection point for electronic scrap
or via your specialist dealer.
Dispose of used batteries in a recy-
cling bin for batteries or via the
specialist trade.
Put the packaging material into the
recycling bins for cardboard, paper
and plastics.
Hereby, ELDAT GmbH declares that
the radio equipment type SH01 is in
c o m p l i a n c e w i t h D i r e c t i v e
2014/53/EU.
The full text of the EU declaration of
conformity is available at the follo-
wing internet address: www.eldat.de
Warranty
Within the statutory warranty period we
undertake to rectify free of charge by repair or
replacement any product defects arising from
material or production faults.
Any unauthorized tampering with, or modifica-
tions to, the product shall render this warranty
null and void.
Service
C
32
CR2032
+
Replacing the Battery
voltage
Connecting the protective low
1. L
2.
Replace the battery. Only use batteries of
the type CR2032.
Make sure the poling is
correct. The positive pole has to be
visible!
3.
Replace the transmission group back onto
the catches.
Note:
Two seconds after inserting the battery,
the Easywave code B2 is sent automatically.
ever off the transmission group.
The humidity sensor can also be operated with
12-24 V AC/DC low voltage.
Use flexible equipment wires Ø 0.5 to 0.6 mm
for this purpose. These must be stripped 8 mm.
1. L
2.
Remove the battery and insert the wires
into one of the borings KL1 and KL2 on the
circuit board. The wire is clamped into the
spring contact on the rear and cannot be
removed again without destroying it.
The second boring KL1 or KL2 is intended
for looping through, if applicable.
3.
Re-attach the
to the
catches.
Note:
Two seconds after activating the supply
voltage, the Easywave send code B2 is sent
automatically.
ever off the transmission group.
transmission group
1.
1.
2.
2.
KL2
KL1
Trouble Shooting
If the radio receiver does not react to the Radio
humidity sensor :
Radio humidity sensor
- Exchange the battery.
- Check that the wireless connection at the
installation site is not impaired between the
and the receiver.
- Memorize the transmission code in the
receiver.
- Other wireless devices using the same
frequency or working in direct proximity
may interfere with the device.
UM98473B 1017 GB
