GB CBA-030
7
Warning:
Adhere closely to the following advice
•
Install in such a way that there is always adequate heat disposal.
•
Always install under other equipment which produces or spreads heat.
•
Adhere to the instructions and distances indicated for installation.
•
Check that the absorption and consumption of the connected equipment are compatible with the enclosed
technical characteristics.
•
Do not try to recharge non rechargeable batteries.
•
When charging lead batteries, place the battery in a well-aired area.
•
The connection to the mains must be made in accordance with the national installation rules.
•
The equipment must be earthed via the relevant terminal.
•
Connect the equipment to the battery without other conductor cutouts.
•
Disconnect the equipment output terminals before any interventions on the battery.
•
Handle and connect without mechanically stressing the electronic card.
•
Make sure that no copper conductor cuttings or other waste material fall inside the equipment.
THIS BATTERY CHARGER IS NOT SUITABLE FOR OPERATING IN THE FOLLOWING
CONDITIONS:
•
Where the environmental temperature is outside the limits indicated in the enclosed technical sheet.
•
Where the air pressure and temperature variations are so rapid as to produce exceptional condensation.
•
Where there are high levels of pollution caused by dust, smoke, vapour, salts and corrosive or radioactive
particles.
•
Where there are high levels or heat from radiation caused by the sun, ovens or the like.
•
Where attacks from mould or small animals are possible.
•
Where there is the risk of fire or explosions.
•
Where the battery charger can receive strong vibrations or knocks.
•
Where the equipment is protected by barriers or casing with protection level less than IP20.
ELECTROMAGNETIC COMPATIBILITY
This battery charger functions correctly only if inserted in plants which conform with the CE marking
standards; it meets the exemption requirements of the standard EN50082-2 but it cannot be excluded that
malfunctions could occur in extreme cases due to particular situations.
The installer is responsible for checking whether the levels of disturbance are above those consented by
the regulations.
CONDUCTION AND MAINTENANCE
The following maintenance operations should be performed every week:
- check that the indicators function;
- check the batteries;
- check that the conductors are tight, check the condition of the terminals.
UNLESS WE MAKE A WRITTEN DECLARATION STATING THE CONTRARY, THIS BATTERY CHARGER
IS NOT SUITABLE FOR USE AS A CRITICAL COMPONENT IN EQUIPMENT OR PLANTS RESPONSIBLE
FOR KEEPING PERSONS OR OTHER LIVING BEINGS ALIVE.
Used only to maintain the battery charge. Used in the starting circuits of diesel and petrol
engines, such as those used in genset units, close-coupled pumps, compressor motors, etc.
Constructed for installation only inside the electric panel.
NOTICES
YOUR ELECTRICAL TECHNICIAN CAN ASK ANY QUESTIONS ABOUT
THIS BATTERY CHARGER BY TELEPHONING OUR TECHNICIAN
Any use which differs from that which is indicated in this instruction and user manual must be authorized
by the manufacturer.
Содержание CBA-030 230/12 V
Страница 5: ...GB CBA 030 5 127 6 ...
Страница 6: ...GB CBA 030 6 127 6 ...
