E L C A R T
servizio automatico documentazione tecnica
ELCART DISTRIBUTION SPA via Michelangelo Buonarroti, 46 - 20093 Cologno Monzese (Milano) ITALY
Tel. ++39(0)2/25.11.73.10 Fax ++39(0)2/25.11.76.10 sito internet: www.elcart.com e-mail: [email protected]
La divulgazione dei dati contenuti in questa scheda è da ritenersi un servizio puramente informativo e non costituisce alcun vincolo da parte della Elcart in merito a prestazioni ed utilizzo del prodotto.
ART. 28/70900
PAGINA 7 DI 8
MOUNTING INSTRUCTIONS
When hanging the device on a wall, PAY CAREFUL ATTENTION to these instructions and to
the precautions in this manual and respect all local laws and regulations!
If the device is installed in a bathroom, a location must be chosen that allows for a
surrounding “safety distance” that must be ALWAYS MAINTAINED.
1) Before installation, verify that the wall
and location is suitable for such a device.
Also make sure the wall is thick enough
to support the device.
Fig. 2
2) See (Fig. 2) below. Drill 2 holes in
the wall at exactly the distance of
the 2 holes on the wall support
piece (approximately 80mm.)
Naturally the holes will have to be
large enough to accommodate
anchor plugs (optional) that, if used,
would be inserted before the screws.
1) Fix the support to the wall using the reinforcement anchor plugs (optional);
2)
Connect the power cable to a 220V power plug, making sure the Mains Voltage is
compatible with the appliance.
Fixed Connection
This operation must be accomplished by a qualified professional—only after the unit’s plug has
been removed from the power socket and the mains current has been cut off.
1) Detach panel by removing the screws, and disconnect the power cable from the inner
terminal by loosening the screws.
2) Connect power cord (AFTER cutting the mains current!) as follows: Fan wire – Position
terminal “L”, Neutral Wire – Position terminal “
N
” Ground wire – position terminal “
”
(Fig. 3)
Always connect the “Ground” wire first,
but only AFTER having cut the mains voltage!
