ELCA AT E1-MIA, Руководство пользователя

Страница: 36 / 50

ENG man E1-MIA 00 E1-MIA Radio Remote Control
- Page 7 -
ENGLISH
Before proceeding with any kind of maintenance operation, make sure that:
- the receiver is NOT powered;
- the transmitter is off
- the mushroom STOP button is activated.
In the event it is necessary to intervene on the machine or on the receiving unit for maintenance operations:
- electrically disconnect the receiver unit from the machine.
Even though the radio remote control system does not require special maintenance operations, some precautions are
nevertheless necessary so that it remains fully efficient at all times.
Controls to be carried out daily before using the Radio remote control:
- Check that the mushroom Stop button functions correctly; the pressure exerted on the button must not be high and
the reset must take place without friction or forcing.
- With the mushroom button pressed, press the Start command. The red LED should light.
- Check the integrity of the transmitter's plastic casing. It should not have cracks.
- Check the integrity of the rubber of the keyboard buttons. It should not have cracks or holes.
Controls to be performed weekly:
- Clean the transmitter with a damp cloth and verify its integrity.
- Clean the charge contacts before proceeding to recharge.
- Check the integrity of the receiving unit. The casing should not have cracks.
Controls to be performed monthly:
- Clean the receiving unit with a damp cloth and assess its integrity.
- Clean the contacts of the charging system's power supply.
Controls to be performed yearly:
- Open the receiving unit and verify the integrity of the internal components. There should be no residual moisture
or oxidation.
- Check the integrity of the receiving unit's gasket on the cover.
- Check the seal of the cable on the cable glands.
- Perform a full charge in the event of prolonged disuse of the system.
In addition to the above recommendations, in order to maintain the efficiency of the radio remote control System, the
following precautions should be carried out:
- Protect the transmitting unit from jets of water or rain.
- Remove the receiving unit if it is installed externally during transport. In case of rain during transport, the receiving
unit's IP level may not be sufficient to prevent water seepage.
- Do not leave the transmitter unnecessarily exposed to direct sunlight or heat sources.
2.6 MAINTENANCE