Setup menu
Enter the setup menu from the main screen by pressing
By using the encoder select the item you would like to adjust.
Options:
•
Edit DMX port 1 to 8 or DMX input 9 and 10
•
Set the ID
•
Rename the current configuration
•
Change network settings (ip address and netmask)
Edit the item by pressing A or the encoder.
All settings will be stored AFTER exiting the setup menu via the
key, a
message will appear.
Edit DMX ports 1 to 8 or DMX input 9 and 10
Use the encoder to change the current selected option and press the
encoder to select the next option.
Press A to store the configuration
Press B to set the DMX port to it’s default value
Press
to cancel any changes
DMX port as output
When a port is set up as a DMX output, then you can select the working
mode of that port. Modes are:
•
disabled
the DMX output is disabled
•
outzero
the DMX sends out a DMX test signal with all channels at
0%
•
single
the output sends out the DMX values of the selected
(primary) ArtNet universe. The DMX output is enabled the first time it
detects the DMX universe on the network (or internal DMX inputs). If
the universe on the network fails, the DMX output will go into DMX
hold.
