Detector 3000
Seite 9 / 11
Stand: 29.8.19 GB
•
Hold the voltage tester with the sensor
against the wire or cable. The voltage tester
indicates the strength of the signal digitally on the LCD screen.
•
Store test probes safely to avoid any unintended connection
•
Tester switch to voltage measurement if voltage >6V or Single Pole is detected between
probes
7.10.
Torch light
•
Press the “torchlight” button to turn on the light and after approx. 30s it will turn itself off
7.11.
Self test
•
LEDs and all LCD segments and vibration motor, torch light, ELV indication and buzzer are
turned on for a second after battery replacement.
Selftest can be activated:
Shorting L1(-) and L2(+) probe tips while device is turned OFF – leave device OFF
for 30 seconds before shortening tips.
7.12.
HOLD Function
•
Long press (2 seconds) on “torchlight/function” button activates HOLD function and freezes
display value. With short press on “torchlight/function” button freezing of display is released.
When HOLD function is active
symbol will be shown on LCD.
7.13. Backlight
•
White Backlight is turned on when torch light is turned on
8. Battery Replacement
Remove the probes from any testing point, when opening the Battery case. Batteries are
dead when the continuity test with both test probes connected cannot be done anymore
and the low battery symbol is shown in the LCD.
Follow the procedure below and replace batteries with new ones (type IEC LR03 1.5V).
•
Unscrew the battery door
•
Pull out the Battery door and replace the batteries. Insert new batteries according to the
engraving on the Battery door.
•
Re-assemble battery door.
Confirm that the Battery door case is properly locked prior to measurements.
