REBLE610 Fully indoor Microwave Link
Page 26 of 52
Version 1.4
Directional arrows “LEFT”
and “RIGHT”
to browse between each connector page (A, B, C,
D, E, F, G, H, J, K).
Moreover, the display shows following information:
Tag
Type
Description
Mapper
Text
Associated transport channel number indication (inputs should not use the same
number, while outputs do).
Bitrate
Text
Bitrate indication.
Packet
Text
ASI packet format indication (188/204).
Locked
Led
Carrier detected indication, that is the ASI signal presence (valid only for inputs).
Carrier
Led
Timing indication, that is interface data are locked to modulator or to demodulator.
Timing Error
Led
Overrun indication, that is buffer level is above “Almost Full” threshold.
Overflow
Led
Underrun indication, that is buffer level is under “Almost Empty” threshold.
Underflow
Led
Carrier detected indication, that is the ASI signal presence (valid only for inputs).
7.6
Menu Transmitter (TX).
The Transmitter menu consists of a single page that allows monitoring and setting of the most important
parameters of the transmitter module; the menu is accessible only for FD or Tx devices.
Figure 41
:
Transmitter menu.
Active areas:
Directional arrow “UP”
to go back to main menu.
Checkbox for the squelch of the transmitter.
The page also shows three icons that correspond to the alarm led
:
1.
An alarm for the oscillator status (in case of oscillator unlock, the transmitter is silenced through
hardware pin).
2.
An alarm indicating low power at the transmitter output.
3.
An alarm indicating that the temperature of the module is higher than 60°C.
Moreover, the page reports temperature and power output measurements.
7.7
Menu Receiver (RX).
The Receiver menu consists of a single page that allows monitoring and setting of the most important
parameters of the receiver module; the menu is accessible only for FD or Rx devices.
