Elba VETRO EDDH-C9046STSS, Инструкция по эксплуатации

Страница: 8 / 13

you turn the box according to your requirements in a certain direction can (Fig.9))
6 out of the wind pipe connected using the supplied screws (screw package) 3 2.2 * 6.5 a fixed cast
in the wind the other end into the vent or outdoor Figure (Fig.14).
External motor installation method:
(1) Refer to Figure Fig.2 open mounting holes on the stove:
a) If you want to install the hood decorative panels flush with cooker, Fig.3 diagram to open the
mounting holes.
b) If you want to smoke decorative plates and cooker separate Fig.4 diagram to open the mounting
holes.
The box on the hood Remove the screws will be separate from the hood (same as Fig.7).
Hood into the stove openings, pay attention to Handle with care to avoid the decorative plate
deformation. Such as (Fig.8)
The hood decoration board and stove flush with the mounting foot fixed, tile stove, the top two
mounting foot can not install as shown in Figure (Fig.10, Fig.11)
5 box install back on the hood, as shown in (Fig.15). External box fixed outside the cabinet using a
fixed external box comes with screws to the duct, the other end fixed to the hood on.
Remove the power supply box inside the small cardboard box, plug in the connection plug and the
body of the above to the corresponding plug. Figure (Fig.16)
Use and maintenance
Replacement of charcoal filter
Activated carbon cover to loosen four screws with a screwdriver to remove it as shown in Figure
Fig.17
Activated carbon framework pull up out of the box.
Carbon in two snaps down the pressure will be able to activated carbon to come up with.
Installation and can be opened in reverse order.
The activated carbon filter played a role in air purification. After every four months, this filter
would be inappropriate to continue cleaning or use, must be replaced. Cleaning or replacement of