Elba ETP-F5082, Руководство пользователя

Страница: 8 / 10

AUTO CUT-OFF
1. When the appliance is dry boiled, the thermo pot will automatically cut off the power.
2. The auto CUT-OFF function will also operate when:

The power is switched on, but no water is filled in the water tank.

Water level is below the MIN water level mark.
CLEANING AND MAINTENANCE
1. Always allow the appliance to cool down before cleaning.
2. Remember to unplug the plug from wall socket and connector.
3. Open the lid and pour out the remaining water in the water tank.
Wipe the lid and body with a damp cloth.

Never immerse any part of the thermo pot in
water.

Never splash water on the control panel.

Do not use abrasive materials to clean the
appliance.
To re-boil water under keep warm mode
1. Press the
“re-boil” button once. “Boil” light
indicator (in red) will be on.
2. After re-boiling process is completed, the
keep warm light (in green) will turn on.

Re-boil will not function if there is
insufficient water inside the water tank.

Press the re-boil button immediately after
the water boiled will have no effect as the
water is already at the temperature of
100

C.

It will take about 3 minutes to re-boil water (with
full water tank) depending on the water
temperature.

Before re-boiling the water, make sure the
water level is sufficient.

When adding water into the water tank, be
careful of the hot steam from steam vent and
water tank.

Once the re-boil button is pressed, the boiling
process will begin and you cannot reset any
button until it turns to keep warm mode.

Do not press the re-boil button continuously
(after re-boiling process) as it may cause
malfunction.