Elba EHS 635 SB, Инструкции по использованию - Советы по установке

Страница: 17 / 28

17
30 mm
FASTENING THE COOKTOP
(fig. 3.4)
Each cooktop is provided with an installation kit including brackets and screws for fastening
the top to fixture panels from 2 to 4 cm thick.
• Cut the unit.
• Stretch gasket “ D ” over the edge of the hole made, being careful to overlay the junction
edges Turn the cooktop over and put tabs “ A ” into the mountings, only tighten screws
“ B ” a few turns.
Make sure that the tabs are mounted correctly as shown in the figure 3.4.
Turn the tabs so that the cooktop can be put into the hole.
• Put the cooktop into the hole cut into the unit and position it correctly.
• Put tabs “
A
” into place, tooth “
C
” of the tabs should go into the hole.
• Tighten screws “ B ” until the cooktop is completely secured.
• Using a sharp tool cut off the part of gasket “
D
” which protrudes from the cooktop.
Take care not to damage the benchtop.
20 mm min. 40 mm max.
B
D
A
C
Fig. 3.4
Fig. 3.3
Space for
connections
Door
Clearance
INSTALLATION IN KITCHEN
CABINET WITH DOOR
(fig. 3.3)
It is recommended that a 30mm clearance
be left between to base of the cooktop and
the separator.
The separator shall be heat resistant, made
of low thermal conductivity material and
shall be removable with the use of a tool for
installation and service.