Elba EGV 13, Инструкция по эксплуатации

Страница: 24 / 52

24
TECHNICAL INFORMATION FOR THE
INSTALLER
Before installing the cooktop, remove the protective film.
This cooktop can be built into a working surface 30 to 40 mm
thick and 600 mm deep.
Mount an extractor hood above these appliances to remove
fumes and smells produced during operation.
650 mm
50 mm
450 mm
300 mm
Fig. 4.1
To fit the cooktop into the unit make an opening of the
dimensions given in the figure, remembering that:
✓
inside the unit there must be a space of at least 30 mm
between the bottom of the cooktop and the top of an
appliance or bracket.
✓
any wall to the side and above the cooktop must be at least
300 mm away.
✓
the wall behind the cooktop must be at least 50 mm away.
✓
the rear wall must be at least 50 mm from the ceramic griddle
and must withstand a temperature of 150°C.
✓
when there is a wall unit or hood above the cooktop there
must be at least 650 mm between the cooktop and the unit
or hood.
✓
the coatings of the walls of the unit or appliances near the
cooktop must be heat resistant:
“X” protection against heating in compliance with standards
EN 60335-2 6.
Do not install the cooktop near inflammable materials
(e.g. curtains).
A
A
A
A
Fig. 4.2
30
mm min.
40
mm max.
B
D
A
C
Fig. 4.3
FASTENING THE APPLIANCES
Each cooktop is supplied with a set of tabs and screws to fasten
it on units with a working surface from 3 to 4 cm deep.
✓
Cut the unit (as shown in the figure on the previous page).
✓
Stretch gasket “D” over the edge of the hole made being care-
ful to overlay the junction edges.
✓
Turn the appliance over and put tabs “A” into the mountings;
only tighten screws “B” a few turns.
✓
Make sure that the tabs are mounted correctly as shown in the
figures at the side. Turn the tabs so that the appliance can be
put into the hole.
✓
Put the cooktop into the hole cut into the unit and position it
correctly.
✓
Put tabs “A” into place, tooth “C" of the tabs should go into the
hole.
✓
Tighten screws “B” until the appliance is completely secured.
✓
Using a sharp tool cut off the part of gasket “D” which pro-
trudes from the cooktop.