Elba E 5531 FG2 BK, Инструкция по использованию

Страница: 31 / 40

31
Gas connection with rubber hose holder
Note: if not already fitted on the inlet pipe,
the hose holder is supplied with the product in a separate kit
(Important: to be used ONLY IF PERMITTED by the local applicable regulations)
Manifold
male
pipe fitting
Inlet pipe
Hose holder
for LPG
Hose clamp
(not supplied)
LPG
Rubber hose (not supplied)
for LPG connection
(internal diameter 6 mm)
1/2” G cylindrical
(ISO 228-1) male
1/2” G cylindrical
(ISO 228-1) female
Sealing
washer (#)
(#) If not already fitted on the inlet pipe,
it is supplied with the appliance in a
separate kit
Fig. 7.2
GAS CONNECTION WITH RIGID PIPES OR A FLEXIBLE PIPE
The gas connection is made up of:
• the terminal fitting of the inlet pipe
• sealing washer.
Important!
If fitted, remove the hose holder from the terminal fitting of the inlet pipe.
When connecting the cooker to the gas supply with rigid pipes or a flexible pipe,
make sure that
• you use rigid pipes or a flexible pipe complying with applicable local regulations. The
flexible pipe shall be of the correct construction for the type of gas being used.
• if compression fittings are used, you tighten them firmly using two spanners (fig. 7.3).
• the connection with rigid metal pipes does not cause stress or pressure to the gas
piping.
• the flexible pipe is not under tension, twisted, kinked or too tightly bent, neither while
the appliance is in use nor while it is being connected or disconnected.