41
CONNECTION OF THE POWER SUPPLY CABLE
Important! This cooktop must be connected to the electricity supply only by an authorised
person.
To connect the feeder cable to the hob it is necessary to carry out the following operations:
•
Unhook the terminal board cover “
A
” by inserting a screwdriver into the two hooks “
B
”
(fig. 8.1). Open completely the terminal block cover “
A
”.
•
Unscrew the screw “
C
”, then unhook the cable clamp “
D
” by inserting a screwdriver
into the hook “
E
”. Remove completely the cable clamp “
D
” (fig. 8.2).
•
Connect the phase, neutral and earth wires to terminal board “
F
” according to the
diagrams in fig. 8.2; the U bolts “
G
” (fig. 8.1) shall be used as indicated in the diagrams
in fig. 5.2 (they are supplied already fitted to the terminals or inside the terminal board,
behind the cover).
•
Strain the feeder cable and block it with cable clamp “
D
” (by hooking hook “
E
” and
screwing screw “
C
”).
•
Close the cover “
A
” of the terminal board “
F
” (check the two hooks “
B
” are correctly
hooked).
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws fixing
the cover plate behind the terminal block.
If the supply cord (not supplied with the appliance) is damaged, it must be replaced
by the manufacturer or its service agent or a similarly qualified person in order to
avoid a hazard.
FEEDER CABLE SECTION
“Type H05RR-F or H05VV-F or
H05V2V2-F”
220-240 V ac
3 x 4 mm
2
(**)
380-415 V 3N ac
5 x 2,5 mm
2
(**)
380-415 V 2N ac
4 x 2,5 mm
2
(**)
(**) Connection with wall box connection.
–
Diversity factor applied.
–
A diversity factor may be applied to the
total loading of the appliance only by a
suitably qualified person.
Fig. 8.1