Elation SMARTY HYBRID, Руководство пользователя

Страница: 15 / 42

15
www.elationlighting.com
L A M P R E P L A C E M E N T
LAMP INSTALLATION PROCEDURE
3. Unlock retention clip and pull clip towards you away from the lamp.
4. Gently grab lamp base with thumb and index finger and pull towards you.
5.
Gently remove (2) Wires connected to spade terminals on lamp.
6. Gently pull lamp out towards you away from the fixture.
7. Using thumb and index finger, gently install new lamp into the fixture.
8. Gently attach (2) Wires to spade terminals on the base of the lamp. Make sure both wires
are securely attached to the lamp.
9. Install and position lamp so it is seated properly, then secure retention clip.
10. Replace lamp access panel and secure (3) screws marked
“A” , “B” , and “C” .
11. Be sure to reset the
LAMP HOURS in the system menu to prevent the protection circuitry
from accidently shutting off the lamp during normal operation. If the lamp protection circuitry
has already been initiated and the
LAMP HOURS is not reset, the “Replace the Lamp”
warning will continue to flash, and fixture will eventually shut down. To reset LAMP HOURS ,
see instructions below.
LAMP HOURS RESET PROCEDURE
1. Activate the main menu by pressing MODE/ESC and toggle to “Information” .
2.
Press
ENTER
and press
UP
or
DOWN
to toggle to
“Time Information”
.
3.
Press UP or DOWN to toggle to “LampTime Password” and press ENTER .
Press UP or DOWN to enter the reset pass code, “038” and press ENTER to confirm.
The display will automatically revert to “LampTime Password” , next press UP or DOWN
to toggle down to “Clean Lamp Time” .
4.
Press
ENTER
and select
“ON”
. The lamp timer has now been reset, press
MODE/ESC
to exit the menu and return to the home screen.
LAMP OPTIMIZATION
Unlike traditional discharge lamps the Philips
MSD
Platinum 200 FLEX lamp does NOT
require optimization. The lamp orientation and optimization procedure has been preset during
the manufacturing process of the lamp. The lamp is
NOT
a hot-restrike lamp therefore, you
must wait approximately
10 minutes
before attempting to restrike once it has been turned off.