The DP-DMX20L was designed to be mounted onto a truss rig or ceiling. It is
recommended that you use a suitable mounting clamp and safety cable when
mounting over head. There are several mounting holes on the DP-DMX20L in
place for the mounting in various configurations. The mounting bracket can be
reversed by removing the six phillips head screws on the rear- this design is
intended for hanging the pack onto a 2 in pipe or truss without the need of clamps
or other means of hardware. For cooling purposes, it is necessary to mount the
pack so that air is free to circulate around the dimmer. There should be at least 12
inches of clearance between the pack and anything surrounding it.
The DP-DMX20L is supplied with a single 15 Amp Edison plug attached to a 14
gauge line cord. This cord should be connected to a service capable of suppling
20 amps to the pack and be protected by a properly sized circuit breaker.
Lamp loads should be plugged into to the dual 15 Amp Edison sockets which are
supplied on the face of the pack. 3 pin XLR’s are supplied for the DMX input and
output. Connect out of the DMX controller or previous fixture in line and into the
input of the DP-DMX20L. Connect out of the DP-DMX20L and into the input of
next pack or fixture in line. Continue to connect the remainder of your fixtures in a
daisy chain fashion. It is recommended that the last pack or fixture in line include
a DMX terminator into the output. A DMX terminator consists of a 120 ohm, 1/4
watt resistor soldered across pins 2 & 3 of a standard 3 pin XLR connector.
Installation / Mounting
Connections
9
Installation, Mounting & Connections
General Instructions
2
This is a 4 channel portable DMX dimmer/switch pack. Each channel can
individually be set to dim or switch and the pack can function as a one, two or
four channel device. Using the packs digital display, the pack is quick and easy
to set up. There are dual Edison sockets supplied so more than one par or
effect can be connected to each channel. 16 built in chase sequences, with
speed and intensity control, are available for your convenience. Four external
channel fuses allow for quick and easy field serviceability.
This unit must be earthed.
Do not allow for any flammable liquids to come in close contact with the unit.
Do not dismantle or modify this unit. There are no user serviceable parts
inside.
Handle this unit carefully, any strong shock or vibration may result in
malfunction.
When replacing fuses, always replace with the exact same type.
When unpacking, please check the unit for damages. Should you find
something wrong with the unit, please contact the dealer that you purchased
it from immediately.
All rights reserved. No part of this manual may be reproduced, in any form or
by any means, without permission in writing from Elation Professional.
Specifications and improvements in the design of this product and this
manual are subject to change without prior notice.
Notice:
Do not operate this unit if the internal components are exposed.
Only use an AC source that complies with the local building and electrical
codes.
To optimize performance of this product, please read the instructions carefully to
familiarize yourself with the basic operations.
Keep the unit dry, do not expose it to water or high levels of humidity.
Warnings
Cautions
