DMX DUO
10
Editing Shows (Cont.)
10b. Deleting show steps
1. Press and hold down the “Record“ button and simultaneously press chase buttons 1, 6, 8,1, 6, 8 in
sequence. As a result, the Record LED will illuminate. (
Note: if you do not have a DMX controller
connected to the DMX input of the DMX Duo as described in the previous step, you will not be able to
access the Record mode).
2. Select show you want to edit by pressing show buttons 1 or 2. The show LED will continually flash
and the LCD will display the total amount of show steps included into the selected show- “SH:xx“.
3. To view the previously recorded steps, press the same show button, both show and record LED’s
will be lit. Use the “UP/DOWN“ buttons to scroll to the step you would like to delete. Once you find the
step, press the same show button again so that the show LED is flashing.
(You must exit this preview
mode before you can delete the step).
4. Press the “DELETE“ button. All eight chase LED’s will momentarily flash and the LCD will display
the previous show step confirming that the step has been deleted.
5. Repeat steps 3 & 4 to delete additional steps.
6. Press “BLACK-OUT“ twice to exit record mode.
10c. Deleting Shows
1. Press and hold down the “Record“ button and simultaneously press chase buttons 1, 6, 8,1, 6, 8 in
sequence. As a result, the Record LED will illuminate. (
Note: if you do not have a DMX controller
connected to the DMX input of the DMX Duo as described in the previous step, you will not be able to
access the Record mode).
2. Press and hold down the “Delete“ button, then press the show button 1 or 2 you want to delete. All
eight chase LED’s will momentarily flash and the show button you selected will not be lit anymore
confirming that the show has been deleted.
3. Repeat step 2 to delete additional shows.
4. Press “BLACK-OUT“ twice to exit record mode.
Section 11:
Strobe Function Assign
1. Press and hold down the “Strobe“ button and simultaneously press chase buttons 1, 6, 8,1, 6, 8 in
sequence. As a result, the Strobe button LED will illuminate. (
Note: if you do not have a DMX
controller connected to the DMX input of the DMX Duo as described in the previous step, you will not
be able to access the Record mode).
2. From your DMX controller, select a pre programmed strobe scene,
including only the
strobe
channel
, or manually set your strobe or shutter channel to strobe at your desired flash rate.
(For a
pre programmed strobe scene- it is important that you do not include any channel other than the
strobe channel when recording the scene into your universal DMX controller).
3. Press the “STROBE“ button to record and save. All eight chase LED’s will flash momentarily
confirming that the strobe function has been saved.
4. To exit, press “BLACK-OUT“ twice.
