Elatec GmbH
Page 9 of 12
(1) Identification of the assembled product, e.g., name and model number.
(2) Identification of the modular components used in the assembly. A
modular component authorized under Supplier's Declaration of Conformity
shall be identified as specified in paragraph (a)(1) of this section. A modular
component authorized under a grant of certification shall be identified by
name and model number (if applicable) along with the FCC Identifier
number.
(3) A statement that the product complies with part 15 of this chapter.
(4) The identification, by name, address and telephone number or Internet
contact information, of the responsible party who assembled the product
from modular components, as defined in §2.909. The responsible party for
Supplier's Declaration of Conformity must be located within the United
States.
(5) Copies of the compliance information statements for each modular
component used in the system that is authorized under Supplier's
Declaration of Conformity.
(c) The compliance information statement shall be included in the user's
manual or as a separate sheet. In cases where the manual is provided only
in a form other than paper, such as on a computer disk or over the Internet,
the information required by this section may be included in the manual in
that alternative form, provided the user can reasonably be expected to
have the capability to access information in that form. The information may
be provided
electronically as permitted in §2.935.
