REFERENCE GUIDE
EL-NVR-8CH
10024106_REV-A_EL-NVR-8CH
35
www.elanhomesystems.com
ALARM SETUP (CONT.)
‘Click’ settings (
)to enter
NVR SETTINGS
, and ‘press’
ALARM
(
) in the left pane to enter the
ALARM SETUP
page. The setting options are described below.
Alarm Setup > Motion Area
Selecting Motion Detection Areas:
•
Activating individual or multiple Motion Detection Zones
—
‘Clicking’ on individual cells or dragging multiple cells using mouse activates selected motion
detection areas, turning the cells red.
—
When finished selecting zones, ‘click’
Apply
.
—
‘Clicking’
Apply All Channels
applies selected areas to all camera channels.
Note:
This function is disabled for IntelliVision enabled cameras.
Selecting Motion Detection Areas:
‘Clicking’ individual zones or ‘clicking’ while dragging the cursor across the grid highlights the motion
detection areas. ‘Click’ and Apply All Channels to apply the areas to all camera channels.
Alarm Input Type:
Set the alarm sensor to
Normally Open (NO)
,
Normally Closed (NC)
, or
IP Camera
. The last option
will trigger the alarm only when receiving a signal from IP cameras.
Motion Enable:
Switch on/off motion detection. Remember also to set the motion detection area in the tab labeled
MOTION AREA
.
Motion Sensitivity:
Adjust the sensitivity of motion detection. Higher sensitivity indicates that the alarm can be more easily
triggered.
Save Event Snapshot:
Enable to store a snapshot on the hard drive when an alarm is triggered.
