QUICK INSTALL GUIDE
EL-DB
6
7
PLANNING THE INSTALLATION
The ELAN Video Doorbell is primarily designed to be mounted in a portrait
orientation. It can be mounted in a landscape orientation, but the image will need
to be rotated using the ELAN configurator application (for more detail, please see
the Integration Note).
The video doorbell can be mounted flush using the included rough-in mounting
bracket, or surface mounted using the optional Surface Mount Box.
Power may be supplied by Power Over Ethernet (PoE) or by a 12V 2A DC power
supply (not included). PoE must meet the IEEE 802.3at standard. The video
doorbell connects to the local network via a hard wired Ethernet connection.
The video doorbell includes the following connections using the pigtail connector:
b.
Rough-in
The video doorbell mounts to the EL-DB-MB rough-in box using the included
mounting bracket. If surface mounting, use the optional surface mount kit with-
out the rough-in box. See section f. Mounting - Surface
Description
Designator
Network / PoE (RJ45)
DC input, positive (red)
+
DC input, negative (black)
-
Door strike relay, normally closed contact
NC
Door strike relay, common contact
COM
Door strike relay, normally open contact
NO
Door sensor input, positive
DI+
Door sensor input, negative
DI-
Door Chime relay
DB+
Door Chime relay
DB
-
50 in / 127 cm
INSTALLING THE
VIDEO DOORBELL
a.
Mounting Height
The bottom of the video doorbell
should be mounted at a minimum
height of 50 in / 127cm from
the ground for optimized video
coverage.
Place the vapor barrier in the rear of the
rough-in box and adhere the flaps to the
inside of the box. Once the vapor barrier is
in place, cut a slice to allow cable routing.
Mounting to an ELAN DBK-100
Rough-in Box
The video doorbell can be mounted to the
ELAN DBK-1000 rough-in mounting box.
If mounting to a DBK-1000, place the vapor
barrier in the rear of the DBK-1000 mounting
box and adhere the flaps to the inside of the
box. Once the vapor barrier is in place, cut a
slice to allow cable routing.
Attach the rough-in box to the structure.
The rough in box can be adjusted in / out
to accomodate different finish thicknesses.
Use the narrow slots to attach the screws,
the wider slots are used for tool access.
Attach the adhesive gasket to the mounting
bracket (note the alignment of the holes on
the bracket and the gasket making sure they
line up before adhering it). Next, attach the
mounting bracket to the rough-in box using
the included #6 Phillips head screws.
ROUGH-IN BOX
MOUNTING
BRACKET
261-50110xr_clearlake_Product_BigRoughInBox_withScrewsHangPlateandCamera_ViewOne.ai
Place
the gasket
over rear of
rough-in box
and adhere to
the sides of
the box.
261-50110xr_clearlake_Product_RoughInBoxSolo_FrontView_Page6C01.ai
