ELAC MIRACORD 60, Инструкция по эксплуатации и безопасности, Страница: 18 / 24

TROUBLESHOOTING
Symptom Possible root cause Remedy
Motor doesn’t work
No connection to the mains
or mains fuse is blown
Check mains plug, receptacle and fuse
Power supply not
connected properly Check the low voltage plug for
correct fi t and fi x it.
Front switch in position „0“
Switch the front switch to correct position
(33
⅓
or 45).
Audio signals are
reproduced not
loud enough and
eventually distorted The turntable is connected to
the pre amp’s line input. Connect the turntable to the phono input
of your pre amp.
The right channel
appears on left
channel and vice
versa The channels are swapped. Swap the two RCA plugs (left and right
channel) which are plugged into the
turntable’s RCA jacks.
Loud humming noise Metal housing acts as
antenna creating
AC Mains hum Check all connections; for acoustical
check relating major problems reduce
the amp’s volume level to minimum.
Possibly the RCA plugs ground rings
should be readjusted.
Faint humming noise Ground wire not attached In certain cases, it makes sense to
connect the metal parts of the turntable
to signal ground of the (phono-) preamp.
On the rear side of the turntable there’s
an earthing screw for this purpose.
Please use the wire attached to the
included RCA cables for this.
The music pitch
is wrong Wrong speed selected Check which speed should be chosen
for playing the current record. There
are also records on the market which
have the same diameter as an LP (30
cm) but must be played at 45 rpm (e.g.
maxi singles). On the other hand, there
are also records in single format (17 cm)
which should be played at 33
⅓
rpm (so
called “EPs”).
16