16
Installation
Preparations for installation
1)
This In-Wall loudspeaker is already fully assembled.
To install the loudspeaker, it is important that you
separate the entire speaker unit from the cabinet.
Remove the front grille by means of the grille
removal tool.
How to run the cables
ELAC In-Wall loudspeakers can be used with any conventional amplifier.
The connecting cable should run inside the wall. Cable ends with a length of approx. 35-40 cm will come out
of the installation hole.
Use flexible twin cables with a cross section of 2.5 mm² for a line length of approx. 10m and cables with a cross
section of 4mm² for larger line lengths.
Please do not use NYM cables for the installation because they may become mixed up with buried wires .
Note: Mixing up the wires is extremely dangerous and can cause an electric shock!
Appropriate polarity must be ensured. The positive poles of the amplifier outputs (red terminals) have to be
connected to the positive poles of the loudspeaker outputs (red terminals). The same applies for all negative poles,
that must be connected to the black terminals.
Correct polarity is extremely important for connecting the buried loudspeaker units to the amplifier.
