continuously in order to achieve optimal results.
Minimum distance from wall: 0.5 m. The machine
should only be used upright, with feet downwards.
Position the machine in its designated place. Con-
nect the power cable to a single-phase socket fused
for 10 A 230 VAC and protected by a residual cur-
rent device. Turn it on using the on/off button.
The fan will start up. To start heating, turn the
thermostat to the desired setting. The working
range of the thermostat is +5–45°C
INSTALLATION
CHECK BEFORE USE
That the machine is protected by a residual cur-
rent device.
That cables and connectors are undamaged and in
good condition.
Check that the machine is positioned at least 0.5 m
away from the wall.
That the machine always stands on a firm, level
surface.
INSTALLATION
In order to achieve the best drying and heating
performance, the machine should be positioned
as centrally
in the room as possible. The machine must run
OPERATION
HANDLING DURING NORMAL OPERA-
TION
Adjusting the indoor temperature
For maximum temperature, turn the thermostat
knob as far clockwise as it will go.
The thermostat is on the underside of the electrical
box.
Working range +5–45°C
Starting the machine
Start the machine by inserting the plug into a socket.
Then select the desired heating output using the
thermostat. Turn it on using the on/off button.
HANDLING DURING ABNORMAL OPER-
ATION
Resetting the overheating protector.
The overheating protector is reset automatically.
When the machine has cooled down it resets itself
and the heater is switched back on (the fan does not
stop).
Cooling down
IMPORTANT!
The electric element gets very hot (about 300 °C),
so it is vital that it cools down after use in order to
maximise the machine’s lifespan.
This must be done every time the machine is
turned off so that it can be moved.
Turn the thermostat to the 0 position (fully
anticlockwise) and let the fan run for 1–2 minutes
before unplugging the machine from the socket.
EN
