El-Björn A 155F, Руководство пользователя

Страница: 12 / 28

GB
Assembly
Assemble the dehumidifier horizontally on a flat, stable surface
next to a wall. Attach and adjust the feet until the dehumidifier
is standing horizontal.
Attach the two anti-tip devices on either side between the
wwdehumidifier and the wall.
When the dehumidifier is delivered with piping (replacing the
drying lines) for the hanging of laundry, it should be mounted
on the dehumidifier according to instruction provided with the
piping. (Refer to mounting instructions for the piping system.)
Condensate
Attach the clamb connection on the dehumidifier’s
condensate drainage. Connect 15mm pipe from the clamb
connection to the permanently installed drain. The pipe
shall be drawn with fall against the floor drain. A long
drain transport should go up in size of the drain pipe.
The drain is approximately 400mm from the floor on the
left side of the dehumidifier.
Hot water connection A 155HW
Connect the inlet to the upper 15 mm pipe.
Install an external solenoid valve here to regulate the flow.
It is regulated by a thermostat (GT1) in the dehumidifier.
Connect it to 7-8 in the terminal strip.
The water temperature should be <+ 55ºC with a delta
at 10°C (water 55°C - 45°C).
Water flow 5.6 l/min
Rise in temperature 24ºC
Power approx 3,4kw.
ELECTRICAL CONNECTION
Connect the dehumidifier via the circuit breaker to
3N~400V+PE and earth. Fuse with at least a 10A slow
fuse. Connect to the terminal block (X). Use a cable
equivalent to (A05RN-F) 5x1.5 mm
2
.
Connect timers and circulating fan in the proper location
on the strip (X) in the dehumidifier. See the wiring
diagram on back of the electricity hatch or www.elbjorn.
com.
On the A155 HW mounted control of external solenoid
valve for hot water onto 7-8 in terminal (X).
This is controlled by the internal thermostat GT1.
VARNING!
FÅR EJ ÖVERTÄCKAS WARNING!
400V
OBS!
BYT FILTER
REGELBUNDET
VARNING!
FÅR EJ ÖVERTÄCKAS
WARNING! 400V
OBS!
BYT FILTER
REGELBUNDET
CAUTION!
Electrical connection of the dehumidifier and its
peripheral equipment should be carried out by a
qualified electrician according to national
installation regulations.
- 12 -