All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use. Revision 1.3. Released on 27
th
of November, 2012.
STEP 4: REMOVAL OF EK-TIM INDIGO EXTREME:
To disassemble, release the clamping force from the heat sink/water block. The ETI may then be removed (intact) by first slowly peeling each corner. The ETI is designed to adhesively capture excess alloy
(from differences of CPU lid/heat sink interfacial roughness and planarity) on their surfaces. Any residual adhesive on the CPU or heat sink/water block may be removed with Xtreme Clean, acetone, or
xylene and a clean wiper or cotton cleaning swab. Residual alloy is best removed by wetting a swab with Xtreme Clean and gentling rotating the swab to loosen and collect the alloy particles.
Indigo Xtreme is a single-use interface product and any removal of the heat sink (pre/post-reflow) will require a new ETI. All interface material and adhesive residue must be removed and the
CPU and heat sink re-cleaned (with the surface cleaning supplies including in the ETI kit only) prior to the re-installation of a new ETI.
REFERENCES:
The Material Safety Data Sheet (MSDS) for Indigo Xtreme Clean™ can be found at:
http://www.ekwaterblocks.com/shop/EK-IM/MSDS_Indigo.pdf
Contact us for more information about this or other EK-TIM Indigo Xtreme applications at our website:
http://www.ekwb.com
Store EK-TIM Indigo Xtreme at room temperature conditions of 22°C (72°F) and 50% R.H., preferably in the original sealed enclosure and plastic bag.
DISCLAIMER:
EKWB d.o.o. and Enerdyne Solutions are not responsible for any damages due to external causes, including but not limited to, improper use, accident, neglect,
alteration, repair, improper installation, improper testing, or damages caused by overclocking.
AMD FX,™ Phenom,™ and Athlon™ are trademarks of Advanced Micro Devices, Inc., USA.
Indigo Xtreme is a trademark of:
Enerdyne Solutions, Inc.,
125 West North Bend Way, PO Box 2660,
North Bend, WA., 98045 United States of America
