All disclosures, notices and warranty conditions are being written on the back of the box.
Released on 11
th
of January, 2011.
STEP 8: CHECKING FOR CONTACTS
Temporarily remove the water blocks to check for uniform surface contact between the block and the components. Note the pattern of contact on a piece of paper. Then repeat
steps 5 to 7 to reattach the block applying more or less pressure to the areas where you have found it necessary.
STEP 9: POSITIONING FITTINGS
Screw in the fittings, attach the liquid cooling tubes and connect the water-block(s) into the cooling circuit. EKWB recommends using high flow fittings with the EK-RAM
Dominator water block. To ensure that the tubes are securely attached to the barb/fittings, please use hose clamps or an appropriate substitute. The use of an algaecide is
always recommended for any liquid cooling system.
You can use any opening as an inlet/outlet port.
VERY IMPORTANT NOTICE:
Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test
the water block using city tap water pressure. This will rupture the top of the housing and render the block unusable (and will void your warranty).
IMPORTANT DISCLOSURES:
While all efforts have been made to provide the most comprehensive tutorial possible, EKWB assumes no liability expressed or implied for any damage(s) occurring to your components as a result of using EKWB cooling
products, either due to mistake or omission on our part in the above instructions, or due to failure or defect in the EKWB cooling products.
WARRANTY:
Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During this period, products will be repaired or have parts replaced
at our discretion provided that: (I) the product is returned to the agent from whom it was purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has
not been misused, handled carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other than those expressly
set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not affect your statutory rights as a consumer.
This warranty is voided if the
product comes in contact with aggressive UV additives.
REQUIRED TOOLS AND MOUNTING SCREWS:
allen key 2.38 (3-32 inch)
Fittings
Plexi top only:
Two openings for optional
install of two 3mm LED diodes
Note: LED diodes are not encased with the water
block, but they can be purchased separately
through EKWB webshop.
