- 40 -
INSTALLATION OF FITTINGS AND TUBING
STEP 1
Screw in two (2) G1/4 threaded male fittings. Attach the liquid
cooling tubes and connect the water block(s) to the cooling loop.
Do not forget to plug the remaining two openings with
enclosed EK-Plug G1/4 or its equivalent.
EK recommends using EK fittings with all EK water blocks.
CAUTION: When using connectors other than EK fittings,
pay special attention to the length of the fittings male G1/4”
thread - 5mm is the maximum G1/4” thread length allowed!
STEP 1
TUBING
EK- PLUG G1/4
EK-FITTING
CONNECTING THE TUBING
STEP 1
In order to successfully route your tubing, we recommend you check
the liquid cooling scheme.
STEP 1
GPU WATER BLOCK
CPU WATER BLOCK
RADIATOR WITH FANS
AIR FLOW DIRECTION
RESERVOIR
AND WATER-
PUMP
COMBO