- 6 -
INSTALLING THE GPU WATER BLOCK AND BACKPLATE
FAN SPLITTER HUB
To install the water block to your graphics card, follow the instructions
in the link below:
https://www.ekwb.com/shop/EK-IM/EK-IM-3831109833391.pdf
General Characteristics:
- 3x 4-Pin PWM Fan Header (Molex KK 254 Standard)
- 1x 4-Pin PWM Pump Header (Molex KK 254 Standard)
- 1x 2-Pin Tach/PWM Header (Molex KK 254 Standard)
- 1x 2-Pin Power Header (Molex Mini-Fit Standard)
- 1x Power LED Indicator Diode (Red) - Rectified PWM Input
- Uniform PWM Control on All Headers
All the elements that need electricity to run are connected to the fan
splitter hub, located on the back of the unit.
This fan splitter hub contains three 4-pin PWM fan
headers for three fans and one pump.
A 2-pin header is used to connect the hub to the motherboard CPU
fan header to allow the speed regulation of both fans and the pump.
The 2-pin PCI Express Mini-Fit power header is used to provide
power for the AIO unit.
Pump
Fan 1
Fan 2
Fan 3
To the Power Supply Unit
Fan Splitter
Hub
Pump
Header
Fan 1/2/3 Header
RPM (tacho) and PWM Header
Power LED Light
Unit main
Power Header