All disclosures, notices and warranty conditions are being written on the back of the box.
Released on 11
th
of January, 2011.
STEP 3: PREPARING YOUR WATER BLOCK
1. ATTACHING STANDOFFS. Apply small amount of thermal grease around mounting
holes and place acetal standoffs on NB/SB block (thickness 2,1 mm) so the holes are
concentric. Thermal paste provides enough adhesive force for standoffs to stay in a place
for easier installation. This is a crucial step!
2. PLACING BLOCK OVER MB. Place the motherboard on the inverted water blocks
or vice versa and attach them with enclosed screws as shown. Make sure that
mounting holes are aligned. Force the PCIe latch (marked blue) towards lower PCIe
slot when installing the NB/SB part of the block.
STEP 4: ATTACHING BLOCK TO MOTHERBOARD
MOUNTING THE BLOCK. For perfect thermal contact, the block does not use a spring mounting system; therefore when attaching be very careful to tighten all screws equally.
Tightening the screws beginning in the center of the block near the northbridge, and continue evenly outwards. Do not use too much pressure on
screws, because motherboard might bend and either cause bad contact with water block, or break a connection on the board.
Use the enclosed screws and washers as shown in diagram below:
STEP 5: CHECKING FOR CONTACTS
Temporarily remove the water block to check for uniform surface contact between the block and the components. Note the pattern of contact on a piece of paper. Then repeat
steps 3 and 4 to reattach the block. Block was tested on physical hardware. Due to height variations of chipset some differences may occur. In case you have problem with block
contacts please write to our support mail.
STEP 6: POSITIONING FITTINGS AND CONNECTING TO WATER CIRCUIT
Screw in fittings as shown in picture, attach the liquid cooling tubes and connect the water-block(s) into the cooling circuit. The EK-FB KIT GA P67A (UD7) series are not sold
with high flow fittings. To ensure that the tubes are securely attached to the barb fittings, please use hose clamps or an appropriate substitute. The use of an market proved
algaecide is always recommended for any liquid cooling system. You can use any opening as an inlet/outlet port.
REQUIRED TOOLS AND MOUNTING SCREWS:
scissors
philips screwdriver
10 screws M2.5x6 DIN7985
10 PVC washers
Fitting
Use M2.5x6 screws to secure the
water block to the motherboard
PVC washer
