Released on 26
th
of February, 2014.
Installation and mounting manual for EK-DBAY RES SPIN
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EKWB d.o.o. assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the
liquid seal is made using o-rings.
EKWB recommends 24 hour leak testing for all EK products before powering on the computer. This will eliminate any damages that may occur because of the users improper installation or
products imperfections.
STEP 1: GENERAL INFORMATION.
Sample picture of EK-DBAY RES SPIN
STEP 2: PREPARING YOUR RESERVOIR
Take your reservoir and place it on a flat and clean surface. In case you bought extra impellers and you wish to swap the original one then simply unscrew all
screws attaching (with enclosed allen key) the acrylic top to the base of the reservoir and replace impeller. Before closing reservoir make sure the impeller is able
to rotate around it's axis – the easiest way to check this is to blow air gently over the impeller’s blades in order to make sure it spins flawlessly without making
any kind of unusual grinding noises. If you encounter difficulties rotating the impeller please check impeller’s axis shaft. When attaching the acrylic top back to
the reservoir's base avoid using the excessive force since acrylic is prone to cracking. Make sure the rubber gasket is positioned inside it's channel. Usually the
sign of waterproof seal is when gasket flattens against the acrylic top.
STEP 3: MOUNTING THE RESERVOIR INSIDE YOUR COMPUTER CHASSIS:
This reservoir occupies two 5.25” drive bay expansion slots in your computer chassis. Free two slots in case they are already occupied with other
computer components such as optical- or hard disk drives. Place the reservoir in your 5.25" drive bay out with the front plate facing outwards. Secure
the reservoir to the drive bay cage using the enclosed M3x4 DIN7985 screws.
M3x4 DIN7985 screw
