Revision 1.0. Released on 20
th
of November, 2012.
STEP 3: CONNECTING YOU RESERVOIR
Connect two G1/4 threaded fittings to the reservoir (IN) and pump (OUT). Please note the water flow orientation. EKWB recommends using EK-PSC
fittings with the EK-DBAY DCP 2.2 (Original CSQ incl. pump) series units. To ensure that the tubes are securely attached to the barb/fittings, please use hose
clamps or an appropriate substitute.
STEP 4: FILLING THE RESERVOIR, PRIMING THE PUMP
Fill reservoir through G3/8 threaded fill port (marked with arrow) and make sure liquid is not spilled over your computer or any electrical devices nearby. Run
your pump shortly for couple of times to make sure water floods your tubes and other water cooling components. Repeat the procedure until you are done and
pay attention to the water level in your reservoir. Lowest and highest recommendable water levels are indicated on the reservoir's front panel (
min
,
max
). Once
done with the filling process please close your EK-DBAY DCP 2.2 (Original CSQ incl. pump) with G3/8 plug and tighten the seal using enclosed Allen key.
STEP 5: OTHER INSTRUCTIONS
VERY IMPORTANT NOTICE:
Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the computer. We recommend a 24 hour leak test prior to powering
up the computer. Do not test the water block using tap water pressure. This will rupture the top of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the
most comprehensive tutorial possible, EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks cooling products, either
due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.
WARRANTY:
Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During this period, products will be repaired or have
parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the
product has not been misused, handled carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other than
those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not affect your statutory rights as a consumer. This warranty is voided if
the product comes in contact with aggressive UV additives or other improper liquids.
REQUIRED TOOLS:
philips head screwdriver
Water out
(to radiator or water block)
Inlet G1/4
threaded port
EK PSC fitting
Water in
(from radiator or water block)
Tubing
Predrilled holes for 5mm LEDs
(acrylic version only)
EK-DCP 2.2
Water Pump
