- 11 -
STEP 1
Screw-in two (2) G1/4 threaded male fittings. Attach the liquid
cooling tubes and connect the water block(s) to the cooling loop.
Do not forget to plug the remaining two openings with
enclosed EK-Plug G1/4 or its equivalent.
You can use any opening as an inlet/outlet port.
EK recommends using EK fittings with all EK water blocks.
When using connectors other than EK fittings, pay special
attention to the length of the fittings’ male G1/4” thread -
5mm is the maximum G1/4” thread length allowed!
INSERTING THE GRAPHICS CARD INTO THE CHASSIS
Carefully lift your graphics card with the installed water block and
insert it into your PC’s motherboard PCIexpress expansion slot.
Please bear in mind that your graphics card is very likely heavier than
before it was equipped with the water block.
You need to be very careful when handling the
graphics card. Avoid all unnecessary manipulation
of the water block assembly that might damage your
card or water block.
INSTALLATION OF FITTINGS AND TUBING
TUBING
EK- PLUG
G1/4
EK-FITTING
STEP 1
