- 9 -
STEP 5
STEP 5
Tighten the screws in a cross pattern using the enclosed Allen
Key. Stop tightening when every screw is flush with its hole inside
the frame!
STEP 6
STEP 6
Installing Fittings and Tubing:
Screw-in two (2) G1/4 threaded
male fittings. Attach the tubes and connect the CPU water block to
the liquid cooling loop.
EK recommends using EK fittings with all EK water blocks.
CAUTION: When using connectors other than EK
fittings, pay special attention to the length of the fittings’
male G1/4” thread – 5mm is the maximum G1/4” thread
length allowed!
By default, the inlet port is placed on the left side.
FITTING RING
INLET PORT
FITTING BARB