ekwb 3831109821848, Руководство пользователя

Страница: 11 / 12

- 11 -
TESTING THE LOOP
To make sure the installation of your EK components was successful,
we recommend you perform a leak test for 24 hours.
When your loop is complete and filled with coolant, connect the
pump to a PSU outside of your system.
Do not connect power to
any of the other components. Turn on the PSU and let the pump
run continuously. It is normal for the coolant level to drop during this
process as air collects in the reservoir.
CABLE MANAGEMENT GUIDES
The InWin 909EK also includes Cable Guides which can be used
to manage individually sleeved cables, ensuring each wire stays
parallel without the need to disassemble your cable.
To install them, simply pass a cable through the distribution plate
and plug it in. Then place a guide around either side and screw it in
place using the supplied M3x5 Countersunk screws.
Inspect all parts of the loop, and in the eventuality that coolant leaks,
fix the issue and repeat the testing process. Ensure that all hardware is
dry before the system is powered on in order to prevent any damage.