background image

Protecting Your 
Digital Assets

Protecting Your 
Digital Assets

CRU DataPort

®

20 Enclosure

Thank you for purchasing CRU’s DataPort 20. Versatile and affordable, the 

DataPort  20  frame  and  removable  carrier  provide  flexibility  for  standard 

12.7mm slimline optical drive bays. Whether looking for additional storage 
capacity, off-site backup or easy hard drive swapping, the DataPort 20 is the 
solution. This innovative frame and removable carrier combination allows you 
to add removable storage to one of the smallest bays in your computer. The 
DataPort 20 supports one 2.5” 7mm SATA hard drive or solid state drive and 
will operate at 6 Gbps speeds when used with SATA Revision 3.0 drives and 
host.

Features 

•  Designed to fit into 12.7mm slimline optical drive bays

• 

Removable carrier allows quick and easy access to drives for hot 

swapping or data mobility

• 

Mechanical keylock on frame to prevent accidental ejection of the 

carrier

• 

Receiving frame interconnect rated for 25,000 insertions

• 

Transfer data up to 6 Gbps using SATA Revision 3.0 drives and host 

© 2013 CRU Acquisition Group LLC, ALL RIGHTS RESERVED. DataPort® and CRU

TM

 are trademarks of CRU Acquisition 

Group, LLC and are protected by trademark law.

Product Warranty

CRU warrants this product to be free of significant defects in material and workmanship for a period of five years from the origi

-

nal date of purchase. CRU’s warranty is nontransferable and is limited to the original purchaser.

Limitation of Liability

The warranties set forth in this agreement replace all other warranties. CRU expressly disclaims all other warranties, including 
but not limited to, the implied warranties of merchantability and fitness for a particular purpose and non-infringement of third-

party rights with respect to the documentation and hardware. No CRU dealer, agent, or employee is authorized to make any 

modification, extension, or addition to this warranty. In no event will CRU or its suppliers be liable for any costs of procurement 
of substitute products or services, lost profits, loss of information or data, computer malfunction, or any other special, indirect, 

consequential, or incidental damages arising in any way out of the sale of, use of, or inability to use any CRU product or service, 

even if CRU has been advised of the possibility of such damages. In no case shall CRU’s liability exceed the actual money paid 
for the products at issue. CRU reserves the right to make modifications and additions to this product without notice or taking 

on additional liability.

FCC Compliance Statement: “This device complies with Part 15 of the FCC rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.” 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is 
operated in a home or commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, 
if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. 

In the event that you experience Radio Frequency Interference, you should take the following steps to resolve the problem: 

1) 

Ensure that the case of your attached drive is grounded. 

2) 

Use a data cable with RFI reducing ferrites on each end. 

3) 

Use a power supply with an RFI reducing ferrite approximately 5 inches from the DC plug.

4) 

Reorient or relocate the receiving antenna. 

FOR HOME OR OFFICE USE

A6-020-0001-1 Rev. 2.0

Product Models

DataPort 20

Host Interfaces

• 

SATA: up to 6 Gbps

Drive Types Supported

2.5 inch SATA (Serial-ATA) Hard Drives

Connectors

One (1) SATA data connector
One (1) SATA 6-pin slimline power connector                               

Operating System
Requirements

• 

Windows 8, 7, Vista, or XP

• 

Windows Server 2012, 2008, and 2003 product families

•  Mac OS X 10.4.x or higher
•  Linux distributions that support the connection type used

Torque

2.5 inch hard drives, M3 screws: 4 inch-pounds max.

Compliance

EMI Standard: FCC Part 15 Class B, CE
EMC Standard: EN55022, EN55024

Shipping Weight

0.68 pounds (includes accessories)

Product Dimensions

4.96” x 0.5” x 5.04” (126mm x 13mm x 128mm)

Technical Support

Your investment in CRU products is backed up by our free technical 
support for the lifetime of the product. Contact us through our website, 

cru-inc.com/support

 or call us at 1-800-260-9800 or +1-360-816-1800.

Reviews: