These products are intended for installation by expert users only. Please
consult with a qualified technician for installation. Improper installation
may result in damage to your equipment. EK Water Blocks assumes no
liability whatsoever, expressed or implied, for the use of these products,
nor their installation. The following instructions are subject to change
without notice. Please visit our web site at www.ekwb.com for updates.
Before installation of this product please read all important notices,
disclosures and warranty conditions printed on the back of the box.
Before you start using this product please follow these basic guidelines:
Read the entire manual before you start installation!
Please remove your motherboard from the computer to ensure the
safest possible mounting process and to prevent the possibility of
damage to your GPU or any printed circuit boards (PCB’s).
EK-Quantum Torque fittings require only a small amount of force
to screw them firmly in place since the liquid seal is ensured by
compression of the rubber O-ring gaskets and not the thread itself.
Only G1/4 fittings with a parallel thread should be used (1/4” BSPP),
maximum thread engagement is strictly 5.75mm!
The use of corrosion inhibiting coolants are always recommended
for any liquid cooling system.
Do not use pure distilled water! For best results EK recommends the
use of EK-CryoFuel coolants!
Make sure to thoroughly bleed air out of your CPU Water Block or
you will not achieve optimal performance!
