EKOM DK50 B, Руководство пользователя

Страница: 14 / 104

INSTALLATION
NP-DK50 B-A-1_02-2021 14 02/2021
9. INSTALATION CONDITIONS
9.1. Handling and releasing the compressor
Fig. 2: Handling the compressor
Prior to installation, ensure that the compressor is free of all transport packaging
and stabilizers to avoid any risk of damage to the product
Fig. 3: Releasing the air pumps
Compressor with base DK50 B (Fig. 3)
After removing all packaging material, place the product on the floor and remove stabilization parts
X and Y (Detail A). Direct the output pressure hose, drain hose and power cord out the back of the
compressor.
Compressor in box DK50 BS (Fig. 3)
After removing all packaging material, place the product on the floor and remove stabilization parts
X and Y (Detail A). Direct the output pressure hose, drain hose and power cord out the back of the
compressor. Slide the box over the compressor so that the front face of the box matches the front
part of the compressor and the box is fully seated. Make sure that the pressure hose, drain hose
and electric cord come out via the opening at the back of the box. Position the drain hose with its
valve in the holder at the rear of the box.