7
©
2016 Focal Point Fires plc.
POWER ON/OFF
Turns the appliance ON/OFF.
DIGITAL DISPLAY
Digital display of appliance functions.
TIMER
The timer can be programmed to run the appliance/ heater for specific lengths of time (1 hour minimum to 9 hours
maximum).
BACK LIGHTS
Controls back lights ON/OFF light colours; Orange - Blue - Purple - Cycle - Off (LOOP).
HEATER CONTROL
Turns the heater ON/OFF. Hold button for 5 seconds and wait for the display to flash.
0. 18°C/ 64°F - 1. 19°C/ 66°F - 2. 20°C/ 68°F - 3. 21°C/ 70°F - 4. 22°C/ 72°F - 5. 23°C/ 74°C - 6. 24°C/ 76°F - 7.
25°C/ 78°F - 8. 26°C/ 80°F - 9. 27°C/ 82°F - N. ON (LOOP).
FLAME & EMBER LIGHT CONTROL
Controls flame ON/OFF and the ember light colours; Orange - Blue - Purple - Cycle - Off (LOOP) Press button for
5 seconds to lock or unlock the heater.
9.0 OPERATING THE APPLIANCE
GB IE
10.0 SAFETY CUT-OUT SYSTEM
This product has one non-self-resetting overheat protection device (thermal cut-out) which will activate if the air inlets or out-
lets are obstructed. For safety reasons the fire will NOT switch on again automatically, the following procedure must be carried
out before the fire can be operated.
NOTE: The visual effect will remain operational if the cutout is activated, only the fan heater is prevented from working.
Switch OFF the appliance at the wall socket or outlet. Leave the fire OFF for a period of no less than 10 minutes, ensuring all
obstructions are removed. Switch the appliance ON at the wall. Ensure the appliance is turned ON at the control switches. If
the fire fails to operate correctly, repeat the above procedure. If an attempt to switch on the appliance is made before the safe-
ty cutout has reset, the appliance may cutout for a further period of time. If the sequence has been followed correctly and the
appliance still fails to function, check the fuse in the wall outlet. If this is not the cause, call an electrician or maintenance engineer.
Remote Control
The fire is supplied with an IR multifunction remote.
Before the remote will operate the plastic insulating sheet needs
to be removed.
Battery Replacement
Battery Requirements: CR2032
1. Locate and remove the battery bracket.
2. The battery has two sides, one with a button feature, and the
other is flat.
3. Insert the battery with the button side down into the battery
bracket, making sure the battery is firmly seated.
Figure 11
