4
Code
Application program
(## = release)
EK-DH4-TP
APEKDH4TP##.knxprod
Installation procedure - European standard
junction box
The standard base plate also fits the screw seats of a
European standard junction box. In this case, the plate
must be mounted by using two screws using the holes
in the central position matching two diametrally opposite
holes on the box.
Installation procedure - Corner mount
The corner support is fitted with breakout entry holes for
cables and fixing screws; identify the ones most suitable
to your mounting position and pry the holes open.
Fix the corner support on two sides either on an outer or
inner corner.
Outer corner mounting:
Inner corner mounting:
Fix the sensor body to the base plate securely through its
own mounting screws and finally adjust the position of the
sensor head.
Configuration and commissioning
i
Note.
The configuration and commissioning of KNX devices re-
quire specialized skills. To acquire these skills, you should attend
the workshops at KNX cer- tified training centers.
Configuration and commissioning of the device require
the use of the ETS® (Engineering Tool Software) pro-
gram V4 or later releases. These activities must be carri-
ed out according to the design of the building automation
system done by a qualified planner. For the configuration
of the device parameters the corresponding application
program or the whole ekinex® product database must be
loaded in the ETS program. For detailed information on
configuration options, refer to the application manual of
the device available on the website www.ekinex.com.
For the commissioning of the device the following activi-
ties are required:
• make the electrical connections as described above;
• turn on the bus power supply;
• switch the device operation to the programming mode
by pressing the programming pushbutton; the blue pro-
gramming LED (visible through the device lens) turns
ON;
• download into the device the physical address and the
configuration with the ETS program;
at the end of the download, the operation of the device
automatically returns to normal mode. During the pro-
gramming process, the programming LED is turned off.
Now the bus device is programmed and ready for use.
