CG2-SHANTY • CompactPCI GPS Receiver/Clock
- 20 -
EKF Elektronik GmbH • Philipp-Reis-Str. 4 • 59065 HAMM • Germany
Tel. +49 (0)2381/6890-0 • Fax. +49 (0)2381/6890-90 • E-Mail [email protected] • Internet www.ekf.com
JANT
1 2 3
1 2 3
1 2 3
removed
set 1-2
set 2-3
passive Antenna
active Antenna +5V
active A3.3V
WARNING: unmatched JANT settings may destroy antenna
check setting anytime before connecting GPS antenna
Antenna Connector
The Jupiter receiver is equipped with a SMB type miniature coaxial female connector as RF signal
input from the antenna. The antenna cable therefore should provide a matching SMB plug.
When ordering an antenna, be sure to have selected the SMB connector version, if the antenna
cable is directly attached (there are several other common connector types on the market, e.g.
SMA, TNC and OSX). If the antenna is equipped with a built-in connector, an additional adapter
cable is required, matching both, the antenna type of connector at the outer end, and a SMB
male connector on the CG2-SHANTY side. The SMB connector should be a straight type, not
right angle style. A right angle connector might have a profile too low to allow full insertion into
the matching jack on the CG2-SHANTY, which is mounted behind the front panel, due to EMC
requirements.
For best results, use an active GPS antenna with built-in amplifier, especially when the cable
length exceeds 2m. Typical gain is 10...50db; a longer cable needs higher gain to compensate
its loss. Active antennas are powered by +3.3V or +5V across the coaxial cable, selected by the
jumper field JANT. Do not obscure the antenna (mounting outside of the building required).
Heavy Duty Airborne GPS Antenna
