CG2-SHANTY • CompactPCI GPS Receiver/Clock
- 12 -
EKF Elektronik GmbH • Philipp-Reis-Str. 4 • 59065 HAMM • Germany
Tel. +49 (0)2381/6890-0 • Fax. +49 (0)2381/6890-90 • E-Mail [email protected] • Internet www.ekf.com
Installing the Board
Warning
This procedure should be done only by qualified technical personnel. Disconnect the system
from its power source before doing the procedures described here. Failure to disconnect power,
or telecommunication links before you open the system or perform any procedures can result in
personal injury or equipment damage.
Typically you will perform the following steps:
C
Switch off the system, remove the AC power cord
C
Attach your antistatic wrist strap to a metallic part of the system
C
Remove the board packaging, be sure to touch the board only at the front panel
C
Configure any jumpers on the board according to your application (see next page
‘Jumper Configuration’)
C
Identify the related CompactPCI slot (peripheral slot for I/O boards)
C
Insert card carefully (be sure not to damage components mounted on the bottom side of
the board by scratching neighboured front panels)
C
A card with on board connectors requires attachment of associated cabling now
C
Lock the ejector lever, fix screws at the front panel (top/bottom)
C
Retain original packaging in case of return
